Well I finally got a day off to go measure, I still need a pair of rear leafs, CJ ones are narrower, and I am only looking for close to stock lift to build this trailer from the YJ tub and frame. 43" center to center and 3" wide...Thanks, Tim
So I picked up 2 HP 30's and both look bent to me, does anyone locally have the tools to check if either one is bent? If not, I am going to build them...
Well I goofed up and bought 16mm bolts instead of 14mm so I will just take them back. They only had 8.8 in stock which should be strong enough but I am now going to just get the bolts from Belmetric once I figure out the proper length. I also discovered that an AN960 washer added to a...
Pilot snout on the torque converter should keep it aligned, that is all you need to worry about. the friction caused by the proper torque of the bolt will take care of the rest. tim
Ok, where did you get the bolts to mount the calipers? I went to Marshalls, they have the 14x2.0mm but the calipers are supposed to have 14x1.5mm, in 10.9, also where are people getting the washers for spacers? I need .180", .187" are too thick and rub...Tim