Recent content by Jedisdead

The MARS mod on my FT3DR was easy remove rubber plug. Grab resistor with needle nose and twist then reinstall plug. I think it is about the same on all Yeasu radios

Biggest shaft I have seen broke around 80ish splines

He does but it is based in Rock Springs, WY. PolyPro is the name. I don't think they travel to Utah but it might be worth calling he may be able to put you in touch with someone local if not.

I guy I worked with started a concrete lifting company it used a two part foam. My back porch was pumped 6 years ago and is still good. We was using it to lift a bridge for the city. I would make sure you use a foam instead of the sand slurry companies.

We had a master battery switch's on our work trucks(around the same year as yours) and if you flipped it off while the truck was running it would kill the ECM.

Caught this pup about 11 last night

I have tried it once..... half my team indulged in a little too much fireball the first night. We ended you having to go home early.

The gorge is making ice good this year

Left a comment

Just pay the extra here too, Trackers are in a drawer in the house.

Looking for a axle or just housing heading down from Wyoming this afternoon just seeing if there was any thing out there

I wonder if they have ever tried green power bait

Is it tripping at breaker panel or at the compressor? I think #6 is needed for 50amp going off memory.

I would put a amp clamp on it and see how many amps it is pulling. It could just be the little circuit breaker is getting weak.

I have never broke one of these extractors yet and this was in a coal mine setting where everything gets broke https://www.protoindustrial.com/en/industrial-tools/Proto/Specialty-Tools/Extractors/462d2844-86ec-4bf3-9c71-615db7e14b76_Proto%C2%AE-Screw-Extractors/#