Recent content by Kssting

I have the Big Max as well and it maintains 45 degrees in the 3 car garage with very little effort and gets up to 65 in just a few minutes. Picked mine up from Lowes as well. If you don't have a BVent stubbed through the roof already you should hurry - nothing worse than working with stiff...

I have been trying to decide on a skid system for my 4 door JK and wanted to see what skids everyone is running and if you are happy with them. Right now I am considering Synergy, Rockhard, or EVO. Are there any local companies making skid systems?

The Autozone press won't have the offset cup that you will need for the Dana axle so if BCGPER has the right press it will save you lots of time. We angle cut a piece of pipe and it worked but it slipped around. Sent from my iPhone using Tapatalk

I am only running 35's but after snapping the passenger inner axle on the 44 I went with the G2 axles and 20k miles later they are still going strong. For the ball joints, tie rod, and drag link I went with Synergy. The ball joints went on with the truss and I just installed everything else so...

I have had the same Ridgid 18v set for over a year and I use the crap out of it and everything still works great. I used to have all Dewalt tools but they are slowly being replaced with the Ridgids. Sent from my iPhone using Tapatalk

I just stopped by the UHP substation in Farmington and asked one of the officers his opinion and he said that if the fender covers the entire width of the tire and 50% of the height he wouldn't pull the vehicle over. He wrote down the following code section and referenced 2a...

Talk about a strange law. I just looked up the Utah safety inspection manual and it says that a driver side and an interior mirror are required on all vehicles manufactured after 1968 and a passenger mirror is only required if the vehicle has tinted windows. Link to the inspection manual...

You need the rearview mirror and a mirror on the driver side. I drive one of the doorless JKU's with 35's and was pulled over a few months ago by a Centerville officer. I had a motorcycle mirror in my door hinge on the driver side and he checked my paperwork and let me go without a ticket. He...

Some of the early 3.6 2012's have had a valve issue so they need the driver side head replaced but the percentage is small. The issue effected several Jeep and Chrysler vehicles with the 3.6. My 2012 JK was built in May of 12 and so far it has 20k miles and no valve/head issues. I had a 3.8 JK...

Welcome. Its good to see you over here.

When you are installing your exhaust spacers take a look to see if your rear driveshaft is making contact with the evap skid. I had to shift the evap and skid over slightly after I found some rub marks on the rear ds boot and I have the same TF lift.

The jeep and mods look great and I agree the new Rubi wheels look good with the Anvil. I am up for a jk run or any type of run since it would be good to meet you guys.

The 2011-2013 tops have a bigger window in the back. Some of the 13's are "premium tops" not sure what that is exactly but it is supposed to have better fabric and I believe spring assist. The 2010-2013 all have a cable system running along the sides which means that you don't have to tuck the...

The rain sure made Fins more challenging. Even with the rain it was a great weekend. I switched to full rails instead of the stock rails and its one of the best investments I have made so far.

I think we passed each other on Fins on Saturday during the rain. I remember the nice looking Tundra and the front bumper. We were in the Red 4dr Rubicon running it backwards. When we started that morning we had other friends with us in a stock 2 door jeep but they were scraping coming on an off...