Recent content by SuperRunner

Landcruiser FJ80 Full float rear with locker. There is no actuator. I have the plate and the fork as well.

Just buy the stuff and do it, I can help with out some parts like bellhousing and wiring. It isn't too bad. BTW, sale is pending on the 4runner, transaction will be completed this evening. -Rob

The SC setup comes with: m112 intake manifold idler bracket belt inlet injectors modified harness for low impedence injectors water/air intercooler with lines and pump no tuning hardware/software included. That would be an additional $1000.

1987 Toyota 4runner with the 1uz 4.0L v8 motor out of a Lexus LS400/SC400. Engine makes around 260hp and could get up to 20mpg. I did this swap a couple years ago but I had a supercharger on it which is why it has the hood scoop. Figured it would be easier to sell without the supercharger. I...

RIP Josh. Was fun wheelin with ya back in the day. I wish your family well and to remember all the good times. Peace be with you.

I really need some help getting some fabrication done. If there is anybody who wants to do a lexus V8 swap with a manual, and has some free time, PLEASE, I NEED HELP!!! I am located in Orem utah, and in desperate need of some fabrication labor. I just don't have time. With a determined amout...

MCR recycling. They are down on Geneva, somewhere between Center and 8th north. They do it for free.

Greg, on my setup, I used a chevy D44, and I cut down the drivers side 2". I then used a ford shaft(someone hard to find). With this, I was able to move the drivers side inward, alowing me to use the stock toyota spring stance, but because I cut down the drivers side 2", it brought it out...

Greg, go for it? What turbo you going to use? Just don't run over 7psi, and you will be fine. MSD makes a timing retard just for this too. You will probably want to run lager injectors, but then you will need and AFC, and a WB02...$525 for the combo. Get some 7MGE injectors, they are...

Well, I can tell you this, that probably won't work. Turbo's run 80,000 RPMS+

test

Motor is toast. A blown HG doesnt make a clank sound. Probably a rod, but it just didn't puncture the side of the block. I had something like this happen, but it was a screw in the intake. Friend took his truck to Jiffy Lube, and they put a new air cleaner on it. THey didn't tell him...

"Rat" as in the guy pushing. :D :D

Ok, I will problably come pick that back up then. I may try to use it on tobin's swap. You going to be around on saturday?

Hey greg, how goes the swap. Did those headers work? I am supposed to have tobin's done this weekend, but I just barely got the crank and pistons in. Still lots to do.