Recent content by val gibson

do you have water in the oil. i had a crack in a cylinder wall once, and at idle you couldnt hear a knock, but as soon as i gave it gas the knock came alive again. nothing was broke just the crack in the cylinder, i coulndnt even find out how it got there, this happened after about 20k on a...

i would also tend to think it is the iac.

i hope this isnt too dumb of a question, but i just bought a dana 300, and for the rear yoke it just has a round flange. at first i thought this was normal for a cv driveline, but i havent found anything else like this. does anybody know what this style yoke might be? the case has the...

i just painted mine. i got everything from this place in orem just north of center street on 1200 west. they have a section of mismixed. i got a whole gallon of the good stuff for about 40 if i remember right. i was able to buy everything needed from all the chemicals to mix into the paint...

i wouldnt mind doing what would seem to be a simple thing of welding on some wider spring mounts so i can run wider springs if that would help. thanks for the help so far i will check into these suggestions val

hi i have a 75 cj5 with the stock leaf springs. i dont think i want to do a spring over yet, but i do want a couple inches of lift. i think i want 2" for now, but the experience i have with these lift springs is that the ride quality is similar to a tank, and nothing is gained as far as...

hi i am looking to put a tpi engine in my 75 cj. it is a 92 engine with an auto. i will be running a manual so that will have to be changed. from what i think the 92 uses a chip to control things. can anybody help point me in the direction to getting a new chip programmed to make the swap...