Search results

I am looking for some seats that will bolt into my cj-5, I believe yj or cj-7 seats will work.

A company in SLC called Gamut Design, is currently building vehicles called Runts, they also have a fullsized vehicle called a Grunt. Has anyone seen these or had any experience with them?

My heater is not blowing out hot air, it is luke warm at best. I drive a 97 tj with a 4cylinder engine. I don't know much about heater, but it doesn't seem to be working right. Any ideas would be great. thanks

I need a new clutch on my tj, where is a good place to go? Any info would be greatly appreciated. thanks

I just bought a 97 tj se, it runs fine. the only problem is that most of the time when I shift into third gear, it grinds and does not engage until I move the stick a little bit. Is there anything that I can do to help this problem, or do I just have to get a new clutch. I am pretty new to...

A couple of weeks ago I posted a thread regarding building the Dana 35 in my tj, everyone talked me into not spending money on that axle. So I have decide to go with the Ford 8.8 axle. My question is where would be the best place to get one and what should I expect to pay. Is there anything...

I need to get gears and lockers in my tj, it has the dana 35rear and the 30 in the front. Budget is a major issue so I will probably be using lockrights. I am trying to figure out about how much money I will need to spend to do this. any ideas or recomendation for good shops would be apreciated.

would 4:88's work on a 4cylinder tj with 35's?

While removing the front leaf spring hanging bolt on my cherokee the nut that was part of the unibody of my cherokee broke off inside the frame, what can I do now. The guy who was helping me suspected that a local body shop would have a nut that is made to fit inside the unibody, has anyone...

This summer I am buying a tj, the dillema that I am in now is that I have the opportunity to buy a 97, four cylinder for around $3000. It has around 90,000 mi and has never been in an accident. I want to run 35's and want to be able to drive it on the street a little bit as well. My question...

I have a wrecked mid 80's Chev 1/4 ton and I am trying to figure out what rear axle it has. the Diff cover has 10 bolts, but I dont know what it is. Any Ideas?