I picked this truck up in a trade. I don’t remember if it’s a 2000 or 2001 for sure. It’s pretty clean and drives really good. It has a Gear Vendors and a Banks exhaust brake on it. I can’t get them to work. Honestly I don’t have time to play with them and figure it out. It’s low mileage for the...
I’m looking for a new rear bumper for my LJ. Currently has a Warn bumper with tire carrier. It has a lot of movement in it. Anyone have one of there bumpers? Quality? Issues?
I am co President to Sleep in Heavenly Peace in Logan. Sleep in Heavenly Peace started in Twin Falls Idaho in 2012. We build beds for kids that don’t have a bed. Everything is done through donations. We have build days where we get volunteers to come help build the actual frames. Very simple...
I have a Rubicon 44 that I picked up from a rolled LJ. Found out today the passenger side tube is bent. Does anyone have the ability to fix this. I have also wondered if it would be possible to pull the tube out of a Dana 30 and swap them.
We were down playing by the south end of Steel Bender. Came across some obvious man made caves. The caves had chicken wire, plaster, and foam. It almost looked like it had been setup as a prop. Anyone know anything about the caves?
Wondering if anybody has any recommendations for someone that can paint my Lincoln black. Majority of body shops are not interested in a job like this. I’m not looking for a crazy 50k paint job but something of good quality.
I have a 2006 TJ six speed manual with 231 in it. I am getting ready to swap the 241OR Rubicon case into it. I know I will have clearance issues with the body. What the best option? Body lift or lower the transfer case. I am leaning more towards lowering the transfer case an inch just for...
I’m looking at building a shop behind my house. I’m trying to establish a rough budget. Wondering what the going rate for a shop 35 wide 26 deep? Again this is just rough estimates.
My TJ currently has a Dana 30. Early model 3 piece ARB, 4.56 gears with Ten Factory shafts in it. It has Artec lower control arm brackets and Teraflex track bar mount. I have a Rubicon 44 with 4.88 gears and RCV shafts. Still has the stock control arm brackets and track bar mount. I am trying to...