Jeep 4.0 motor, AW4 and Stinkyfab motor mounts

crosbike

Active Member
Location
Utah
1999 Jeep 4.0 engine
Freshened this motor up for my buggy project but now im going the v8 route so this needs to go.
New oil pan, valve cover gasket and new rear main seal.
New high volume oil pump.
New water pump and thermostat too.
I was switching this over to be obd1 so i changed the distributor but i can include.the obd2 too.
Exhaust manifold had a crack but i welded it up. Cleaned the bejesus out of the intake manifold too. New gasket there too.
Newer returnless style fuel rail and older style included
No accessories or throttle body and only stock motor mounts included. $500




Stinky fabrication 4.0 engine mounts for an xj, yj or . Super beefy and ties into a ton more mounts on the engine block.
$150
http://www.stinkyfab.com/heavy-duty...eavy-duty-jeep-xj-4-0l-motor-mounts-87-2.html



1999 AW4 with a new filter and pan gasket. $200
Also have a 1994 xj wiring harness that i wont be needing. $150
I can snag a pic but its a harness.
 
Last edited:

Asbjorn

Active Member
Location
Montrose, CO
I'm in Moab. I'm scheduled to be in Richfield for a day sometime in mid-Sept. If you still have them then I'll grab them. If you are planning to be in or near Moab, let me know and I can meet you somewhere.
 

YROC FAB.

BUGGY TIME
Vendor
Location
Richfield, UT.
I could care less. Its alex's junk not mine, It justs happens to be at my house. I'll have him get on here as he lives high in the mountains with no services.
 
Top