- Location
- Richfield, UT.
Ford Brian's bronco 2 gets wontons and dddd
- Thread starter YROC FAB.
- Start date
- Location
- Richfield, UT.
- Location
- Richfield, UT.
- Location
- Richfield, UT.
- Location
- Richfield, UT.
👌
- Location
- Richfield, UT.
Scavenged Austin's old gas tank and butchered it to work on the bronco. 
- Location
- Richfield, UT.
Brian acquired a bench seat and now there will be tons of room in the back. 
_Auzzy_
Current Rig: 12W Boots
- Location
- Richfield Utah
May as well put my input of what I've done so far on this thing.
First got the new old used radiator in out of my buggy and cut out the last bit of core support it had.
Then I did some work on exhaust. Started from the front back, took off the remainder of the previous system, took off the headers and went over to the belt sander with them, slotted in the middle of the flanges, added new collector gaskets, and ran all new tube back after I fixed the smashed driver side down pipe.
Found a misfire issue also found and fixed a few things like 2 loose spark plugs, the broken coil wire, and the passenger side manifold gasket.
Everything clears all nice and tight almost as if we know what we're doing
First got the new old used radiator in out of my buggy and cut out the last bit of core support it had.
Then I did some work on exhaust. Started from the front back, took off the remainder of the previous system, took off the headers and went over to the belt sander with them, slotted in the middle of the flanges, added new collector gaskets, and ran all new tube back after I fixed the smashed driver side down pipe.
Found a misfire issue also found and fixed a few things like 2 loose spark plugs, the broken coil wire, and the passenger side manifold gasket.
Everything clears all nice and tight almost as if we know what we're doing
- Location
- Richfield, UT.
You forgots to mention the blinging aluminum front links you installed. 👌
_Auzzy_
Current Rig: 12W Boots
- Location
- Richfield Utah
Oh and the limiting straps
glockman
I hate Jeep trucks
- Location
- Pleasant Grove
Cool work as always.
- Location
- Richfield, UT.
- Location
- Richfield, UT.
- Location
- Richfield, UT.
We finally got the rest of Brian's queen shocks. We bent up a floor pan and had to cut off the front shock mounts entirely since the queens were longer and wider than the foxies. We also cut the battery box in half and squeaked the battery behind the seat. 
- Location
- Richfield, UT.
Here's some crap I welded around the fuel tank and lines. 
