Ezalycasaid
Member
I have a set of inner/outter shafts from an HP D60 King Pin axle. Asking $150 Located in Grand Junction CO.
Call or text Chad. 970-270-6432. Thanks
Call or text Chad. 970-270-6432. Thanks
Last edited:
Ford HP D60 King Pin Axle Shafts. 35/30 spline $150
- Thread starter Ezalycasaid
- Start date
- Location
- West Jordan
What year are they from?
Ezalycasaid
Member
Hmmm I dont remember, Ill get some measurements and cross reference them and let u know. They from a build on here about 2 yrs ago that got canned.
Last edited:
Ezalycasaid
Member
I cross referenced them on a chart. I measured from the end of the spines to the center of the bearing caps.
36.75 is the inner pass
16.15 is the inner driver
11.50 is both stubs
So around the 1985 Ford Kingpin lengths
36.75 is the inner pass
16.15 is the inner driver
11.50 is both stubs
So around the 1985 Ford Kingpin lengths
tv_larsen
Well-Known Member
- Location
- Logan, Utah
That Pirate4x4 chart shows:
'85-'88 = 15.96"/36.68"
'88-'98 = 16.17"/36.97"
Can you say if your dimensions are closer to one of those than the other?
I need new inner shafts (mine are pitted on the seal surface). Unfortunately, mine's an '88 and I haven't measured the shafts or found the BOM yet to know which ones I need.
'85-'88 = 15.96"/36.68"
'88-'98 = 16.17"/36.97"
Can you say if your dimensions are closer to one of those than the other?
I need new inner shafts (mine are pitted on the seal surface). Unfortunately, mine's an '88 and I haven't measured the shafts or found the BOM yet to know which ones I need.