- Asking Price
- $150
- Condition
- Used - Fair to Bad Condition
Just like it says, low pinion Dana 60 front with KP Ford 8 lug knuckles.
Was told by the guy I bought it from a few years ago that it was used in the front of a truck pull contest rig. 6.71 Ring gear and pinion were totally jacked, had solid discs welded to the hubs for cutting brakes and a leaking pinion seal. 35 spline inner and outer shafts included.
I changed directions and have just been tripping over it, need it gone. Will get pics and measurements tonight $150
Update: Measures roughly 63.5" WMS-WMS without rotors. Outters appear to be 4340, inners are unknown. Definetly needs king pin bushings and does not have locking hubs.
Inner short side ~18 5/8"-18 3/4"
Inner long side~ 28 1/2"
Outters both about 11 1/2"
Was told by the guy I bought it from a few years ago that it was used in the front of a truck pull contest rig. 6.71 Ring gear and pinion were totally jacked, had solid discs welded to the hubs for cutting brakes and a leaking pinion seal. 35 spline inner and outer shafts included.
I changed directions and have just been tripping over it, need it gone. Will get pics and measurements tonight $150
Update: Measures roughly 63.5" WMS-WMS without rotors. Outters appear to be 4340, inners are unknown. Definetly needs king pin bushings and does not have locking hubs.
Inner short side ~18 5/8"-18 3/4"
Inner long side~ 28 1/2"
Outters both about 11 1/2"
Attachments
Last edited:
