DAA
Well-Known Member
- Location
- West Bountiful, UT
#Carlstuffiscool
- DAA
- DAA
Project: Cheap! But still OK.
- Thread starter I Lean
- Start date
- Location
- East Stabbington
When is the maiden voyage?
There's still quite a bit left to do before it's driveable. Brakes, transfer case stuff, steering box, rear shocks, drivelines, lots of welding, two more wheels to build.....
johngottfredson
Threat Level Midnight
- Location
- Alpine
How do I pre-subscribe to your YouTube channel
I've decided this thing needs to drive on it's own-- either to help my motivation to work on it, or to make it easier to sell to the person who's going to finish it.
So I set the pinion angle for a single-ujoint driveshaft, and visited GRS to get the stocker shortened and stuff. Turns out there is no conversion u-joint for what I need, and the closest thing that exists is a 1350-1410 unit....which the guys at the shop said is junk, and I don't want it. There is no 1410 yoke to go with the 2.75" driveshaft tube.
So as usual, I had to make my own thing. A couple chunks of axle tube welded together made the adapter I needed.
ebryson
Active Member
- Location
- Bountiful, Utah
Did you just turn that on your lathe or did you do something else cool?
Turned on the lathe.
STAG
On my grind
- Location
- Pleasant Grove
Karate chopped it into shape
- Location
- Richfield, UT.
Looks like your on the home stretch of this think. Dont stop meow