Recommend me an adjustable angle clamp for welding.

[Kevin B.]

Short of a proper table, how do you set up odd angles for welding tube? I see that Fireball Magic Square and I want it but I can't spend that much. I also see a couple cheap options on Amazon that look like they're worth every penny you'd pay for them. Is there a middle ground?

https://fireballtool.com/magic-square/

https://smile.amazon.com/Rockler-Adjustable-Clamp-It®-Assembly-Square/dp/B001DSZOCM/

https://smile.amazon.com/Adjustable-Clamp-9133-Corner-Splicing/dp/B0009JGYH0/

 

[frieed]

For on-the-cheap, it's hard to beat a simple protractor/drafting angles to find the angle and 1x2's screwed to a piece of plywood.
Yes the plywood gets burned in places, but just keep an eye on it.

 

[Gravy]

That rockler polycarbonate one will melt FYI

 

[OCNORB]

I've purchased a few Fireball tools and they are good quality.
Their less expensive vices are made in Taiwan, so that was a little disappointing. Still a nicer piece of kit than the HF stuff.