Recent content by Swatdog23

Unstuck, Never herd of a 6l65e, I would be interested if I could find one. I am having a hard time finding a 4l60e. How does in it compare to the 4l60e as far as size.

I have been told I cant use any 4l60e from anything older than a 2006 vehicle. Someone told me it had to do with an internal speed sensor on the stater. Said it would throw a code. I have read through the form but cant find a definite answer. My set will be as follows 2007 Gen IV LMG 5.3...

Benjy, It was nice to talk to you the other day. I can come down and help whenever you need the extra help, just let me know and I will be there. I am all ready to pull out the old 4.2 engine, if you have time and don't mind borrowing your engine hoist I could use it whenever you got time...

No takers these axles sell for 175.00 a piece.(350.00 for pair). I will get the part number so maybe that will help figure out what they will fit. I know the will fit the 90's fords and above. Just need to figure out the bolt pattern of the spindles.

I end up buying the 2007 Chevy avalanche 5.3 for 1250. I have started to strip the wiring harness and have most of it done. I was hoping someone might have the Pinouts for the under the hood fuse box. it is a gen 4 engine and I have not been able to find any pinouts. Its is not listed on...

If you are willing to separate the two I would be interested in the tranny.

Not sure what they will fit I just now they wont fit the old ford axles that I have. I know my axles was way old and was different the most ford axles. pm me your number and I will text you the pic. cant upload they are to big for this post. it is the bolt pattern that is different and that is...

I just found a 2007 5.3 with wiring harness and pcm and all acc. hase 60k on it for $1400 is that a good price or should I keep looking. thanks.

Yukon 4340 Chrome-Moly for Dana Spicer 30 spline . Yukon 4340 Chrome-Moly axles provide up to 50% increased strength over stock axles for use in extreme performance applications with large tires and high horsepower. Yukon’s 4340 axles are manufactured using the latest technologies and the...

Benjy, I live in Saratoga Springs if you have time maybe I could come by and take a look or even help out. Thanks

This is all great information. I have started to read through the post on pirate but have not got all the way through it yet Lol. One question for you guys is I have just completed both front and rear axle swaps, Dana 60 front and rear, I used the Ballistic out board leaf spring kit( Wish I had...

I looking to swap in a Lq4 6.0 into my 84 Jeep CJ-7. I am new to the forum and looking for any advise on the swap and a idea of about how much money it will take to complete the swap. I plan on doing most of the work myself with the exception of the wiring and computer programming. Here is what...