Search results

Looking for a turbo 400. 2wd or 4wd doesnt matter. Ideally i need HD 4wd short output but i can change it too. Needing a rebuild is fine too.

1999 Jeep 4.0 engine Freshened this motor up for my buggy project but now im going the v8 route so this needs to go. New oil pan, valve cover gasket and new rear main seal. New high volume oil pump. New water pump and thermostat too. I was switching this over to be obd1 so i changed the...

I have 2 40x13.5x17 old style goodyear mtrs for sale First one is worn unevenly, has about an 1/8" on one side and 1/4" on the other. The other one has 1/4 across the whole thing. These were bought to mock up my buggy. Located in central utah but i can meet up in nephi or somewhere if...

Never opened shift kit for an aw4 includes drill bits needed. $80 if picked up or $85 shipped Specs TRANSGO PART: 340-HD2 CLASSIFICATION: REPROGRAMMING KIT FITS: 4 Speed Toyota 340, 341, 343 and Jeep AW4 "Year models 1985-2008" FEATURES: Street, Strip & Off Road Increases Clutch Plate...

Purchased this knuckle a few years ago for my mj but this project never happened so ill pass it along. I honestly think it was mocked up on an axle but never used. Should work on any dana 30 minus the jk ones. $300 Obo Specs: High Steer Knuckle Kit by TeraFlex®. Designed to be used with 4+" of...

Dana 300 billet aluminum cover and 3/8 and 7/8 clocking ring. All from 4wheelsupply.net Cover is $40 with no bolts. Supposedly adds rigidity and strength to case. Also increases oil capacity 3/8 ring is $35 7/8 ring is $50 I will be in the salt lake area this weekend if you want...

Teraflex Dana 60 cover Looks virtually new, no dents just a frw scrapes. It was on my 60 when I purchased it. Bolts not included $100obo

I searched a bit but i wasn't sure if anybody had some good suggestions. I have a chevy lq4 (iron block 6.0) with a bent rod that i need repaired/gone through. Where do you guys go?

Looking for 4 or 5 42" tires with a good amount of tread, I need them in a 17" rim for my beadlocks. Ideally would like MTR kevlars Iroks or some kinda swamper maybe pitbulls if its a good deal. Let me know what you guys have. Thanks

Looking for at least 2 with a good amount of tread. Old or new style.

Looking for steel or aluminum beadlocks with an 8x6.5 bolt pattern. 8-9" wide rim and 3.5-4.75" backspacing. Looking to keep it under 600 for 4.

This pedestal gives you a sturdy place to mount your manual tube bender. It will fit the Pro-Tools MB-105 and 105HD benders, all JMR benders, and the JD2 Model 3. Featuring heavy 1/2 inch mounting plates top and bottom, a 2-1/2 inch square .120 inch wall upright, pre-drilled floor mounting holes...

in search for a 92-95 xj obd 1 jeep 4.0 engine harness w/ fuse block, ecu and tcu if you have it. the cheapa the better.

Low pinion front dana 44 axle. Comes with: steering and steering stabilizer Longside inner and outer shaft (needs u-joint) Driver side Knuckle only 4:10 ring and pinion Spindles What it does not have: Cover short side inner and outer Passenger side knuckle Hubs Brakes No yoke What you see...