• DCRC 2024

14 bolt rear steer

C

camdawg

Active Member
I am thinking about putting rear steer on my buggy and I would like some opinions on strength and if anyone has done it? I am planning on using dana 60 king pin knuckls. But also here of people using the ford ball joint knuckls? Where are people getting there custom inner shafts made at? And what shafts and joint will be stong enough? And if I go the ford rout where do you get 35 spline unit bearings ? I am really concerned about the strength. So any info would be appreciated. Thanks in advance camdawg
 
UFAB

UFAB

Well-Known Member
Location
Lehi Ut
We have that all in stock. Machined knuckles. With arms. Inner Cs. Any bolt pattern unit bearing. We can get custom shafts as well. In stock outer 35 spline stubs for the unit bearing.
 
Crinco

Crinco

Well-Known Member
Location
Heber
As a supporting vendor, why dont you have your number, address or email listed so we can get in touch with you to buy products and services? Just wondering...
 
You must log in or register to reply here.
Top