35-Spline Fabricated 9"

[jeepin4x4james]

Fully fabricated housing by Sunray Engineering
63" WMS
Jeep TJ/LJ Discs re-drilled to 5x5.5 with e-brake
Full-Traction truss - used in their TJ/LJ long arm kits
All brackets to bolt-in to a TJ... Spring buckets, sway bar, etc... All brackets are 1/4" or larger
3/8" tubes, 1/4" and 3/8" fabricated center
New-Style (Torino) Big Ford outers
Moser Nodular 3rd, 3.250"
1350 Yoke
.........

New parts with less than 1000 miles....
Moser 35 spline Shafts, Bearings, retainers, studs..
Yukon Master install kit with solid spacer
Yukon 5.13 Gears
Allstar 35-spline Spool
Yukon Daytona Pinion Support
Barnes pinion guard

Also have a used (about 15,000 miles) good condition Detroit locker available if a spool isn't your flavor...


Asking $2000... Can get pics later if interested.
Call, text, PM.... James 8o1 6oh4 o571

 

[UFAB]

Is that semi float?



Sent from my SPH-L720 using Tapatalk 2

 

[jeepin4x4james]

Is that semi float?



Sent from my SPH-L720 using Tapatalk 2

Yes... If it was full float I'd keep it!

 

[gertsch]

I could make it a full float

 

[jeepin4x4james]

I could make it a full float

I was very close to going that route... But I figured the way my rig is evolving it's just gonna keep getting bigger, heavier, more powerful, etc... So might as well just jump up to the 14 bolt.

 

[gertsch]

I don't blame you. Wish I was in the market for a 9" rear

 

[broncomitch]

Just go with rockwells, skip the hole 1ton evaluation lol

wish this was a high 9 setup...been thinking about building a high9 hybrid

 

[jeepin4x4james]

Just go with rockwells, skip the hole 1ton evaluation lol

wish this was a high 9 setup...been thinking about building a high9 hybrid

Haha... If I wasn't keeping it streetable then maybe

 

[jeepin4x4james]

Couple crappy cell phone pics....

 

[jeepin4x4james]

Bump

 

[jeepin4x4james]

Up top. Finally got this pulled out from under my jeep.
Carrier to housing has a small leak, could use a re-seal. Other than that ready to bolt in with extended brake line, e-brake cables, sway bar, etc...

 

[mierdota]

Do you still have this?

 

[jeepin4x4james]

Yep.
I was planning on cleaning it up, resealing the housing, changing the studs (some don't match right now, different length) and painting it before really pushing to sell it... But it's available now