38mm toyota split case

[grinch]

I need a toyota 38mm split case both of the ones I have are 34mm. Don't care if the gears are good or not. I have a new set of reduction gears to go in it... Anybody have one kicking around????

 

[sixstringsteve]

is a 38mm case the same as a 23 spline?

 

[grinch]

Im not sure. Im a little new to the toyota running gear stuff. Split cases were used on the fj60 land cruiser. They are set up for the non centered toyota rear axle. You can tell if its a 38mm or a 34mm case by the main shaft that the gears ride on. A small portion of the shaft sticks out the back side of the case and is held in place by a keeper bolt. They measure either 38mm or 34mm hence the name 38mm split case.

 

[sixstringsteve]

ah. Disregard my comment then.

 

[cruiseroutfit]

Pony Boy!

I owe you a call, been a crazy few days just getting in again for the night. I keep forgetting to call Randy back on his 38mm case: http://www.wasatchcruisers.org/vbulletinfrm/showthread.php?8531-WTB-FJ60-FJ62-38mm-T-case

If his doesn't pan out, lets figure out something on these Marks gears.

 

[grinch]

Sounds good Kurt. Im just a little antsy because im supposed to go on a trip down south again in 2 weeks and I don't want to burn up another clutch with these high gears lol.
Get at me with your plumbing stuff as well. I have all the tools and can make quick work of that job as well.

 

[cruiseroutfit]

10-4, I'm around all day tomorrow. Lets chat and figure out both things!