So I replaced the clutch in my 96 4runner, and there were these wires that are connected to the whole tranny/T-case assembly. I accidentally popped a wire from the female side of a clip on the assembly, and now my runner will not go into 4wd.I move the 4wd shifter, but the light doesn't burn, and I am shure that the vehicle is not going into 4wd. I know that this vehicle has a vacuum oprerated, automatic hubs, and I am wondering if the problem with the wire might be interfering with the automatic hubs, as if they are electronically controlled. Any knowledge would be greatly apreciated,
Jared
Jared