Bradtoyotas
Member
- Location
- St George
97 Dodge Cummins Kingpin Flatbed 7800$
SOLD
7800$ St George UT 1997 dodge cummins 12v 174k miles 5spd 4x4 lifted front end leaf conversion with new 4 inch springs and a ford high pinion kingpin axle, custom flatbed my buddy built with gooseneck hitch in it.. I have invested alot into the truck recently i have replaced--
windshield
new headlights
new airbags
shocks front & rear
new rotors
calipers
pads
power steering box & pitman arm
drag link with chevy 1 ton rod ends
AFE cold air intake
rear drive line, ujoints and carrier, transfercase has been gone through and replaced worn parts including a new tail housing.. Pulled timing cover and fixed KDP and while doing that replaced crank seal and re glued cover, replaced belt and tensioner, every fluid is new..has limited slip in rear 3.54 gears 315/70/16 tires .. recently been aligned. fuel plate is slid forward and cut to a 100 with AFC adjusted.. Drives strait no pulls or dodge death wobbles...drivers fender is rough and i think one wheel could be slighlty bent or just need balancing ...
bradtoyotas@yahoo.com
SOLD
7800$ St George UT 1997 dodge cummins 12v 174k miles 5spd 4x4 lifted front end leaf conversion with new 4 inch springs and a ford high pinion kingpin axle, custom flatbed my buddy built with gooseneck hitch in it.. I have invested alot into the truck recently i have replaced--
windshield
new headlights
new airbags
shocks front & rear
new rotors
calipers
pads
power steering box & pitman arm
drag link with chevy 1 ton rod ends
AFE cold air intake
rear drive line, ujoints and carrier, transfercase has been gone through and replaced worn parts including a new tail housing.. Pulled timing cover and fixed KDP and while doing that replaced crank seal and re glued cover, replaced belt and tensioner, every fluid is new..has limited slip in rear 3.54 gears 315/70/16 tires .. recently been aligned. fuel plate is slid forward and cut to a 100 with AFC adjusted.. Drives strait no pulls or dodge death wobbles...drivers fender is rough and i think one wheel could be slighlty bent or just need balancing ...
bradtoyotas@yahoo.com
Last edited:
