bend-tech ez 3d

[kruzr69]

Does anyone on here have the bendtech ez 3d software? I won a copy on pirate and just got it. It rocks, You just type in all your measurements and it tells you how long of a piece you need, where to start each bend, how many degrees to bend and/or rotate, and how much each piece weighs.
http://www.2020ssi.com/ go to the products page, then bend-tech ez 3d.

 

[Tacoma]

that's pretty badass!

Probably helpful as all get-out if you're trying to work out what something is going to look like ON the truck..

Does it allow for solid shapes, ie fake truck front shapes? or is it all tube?

 

[kruzr69]

that's pretty badass!

Probably helpful as all get-out if you're trying to work out what something is going to look like ON the truck..

Does it allow for solid shapes, ie fake truck front shapes? or is it all tube?

I dont know, you might be able to save it as an image and then copy and paste it on a pic of something. I will have to check it out more.
The 3D part took a little while to figure out how to use it, but once you know excactly what measurements it is looking for, and where to put each measurement it is really simple.
It also lets you print out the part you are gong to bend with the measurements and all the info on it.

 

[Tacoma]

That is hands down the coolest program I've seen.... this week. heheh

Congratulations!