Dodge 35 spline DRW Dana 70 and SRW 60 rears.

[tv_larsen]

I can get a rear axle out of a 2wd Dodge '74 D300 dually. Assuming that it is a 35 spline Dana 70, will the axle shafts fit a Dodge '78 SRW Dana 60 rear with 30 spline shafts?

And yes, I am aware that the spindles will need to be bored larger and the differential side gears/locker must be changed. But is the axle hub flange and shaft length the same?

 

[Hickey]

I doubt the shafts will be the same from a dually to a SRW, they will likely be too long. The hubs should be the same bolt pattern, maybe different wheel depth.

 

[tv_larsen]

I was thinking the shafts were longer on the drw axles, but I hoped I was wrong.