muleskinner
Well-Known Member
- Location
- Enoch, UT
Just making this one for fun. I'll carry it on the job every day and see how it holds up.
This started life as a Simonds 14 Inch Black Master Rasp. I annealed it, then cut most of the knife shape on my band saw.
Ground the profile-
Mark the center line for the edge-
Flat grind @ 120 grit-
Now I'll go drill the pin holes and heat treat it. Then back to the grinder for some finish grinding.
This started life as a Simonds 14 Inch Black Master Rasp. I annealed it, then cut most of the knife shape on my band saw.
Ground the profile-
Mark the center line for the edge-
Flat grind @ 120 grit-
Now I'll go drill the pin holes and heat treat it. Then back to the grinder for some finish grinding.