JeepinGuru
Show em ( o Y o )
- Location
- WesternSlope, CO
well i finally got a 6.0 and working on hacking up the factory engine harness to work on my junk....
here's the setup
2003 LQ4 6.0
th350
D300
on the harness there's 2 pins that goes to the green pin header
http://www.lt1swap.com/2004vortec_pcm.htm
Pin 22 RED/BLK 1230 AT ISS High Signal (4WD w/MT1)
Pin 23 DK BLU/WHT 1231 AT ISS Low Signal (4WD w/MT1)
do i need these or can i remove them since my trans isnt controlled my pcm, im thinking it might tell the pcm that tcase its in Low range to adjust trans shifting points based on speed?
here's the setup
2003 LQ4 6.0
th350
D300
on the harness there's 2 pins that goes to the green pin header
http://www.lt1swap.com/2004vortec_pcm.htm
Pin 22 RED/BLK 1230 AT ISS High Signal (4WD w/MT1)
Pin 23 DK BLU/WHT 1231 AT ISS Low Signal (4WD w/MT1)
do i need these or can i remove them since my trans isnt controlled my pcm, im thinking it might tell the pcm that tcase its in Low range to adjust trans shifting points based on speed?