broncomitch
dont be a sheep in a jeep
- Location
- west jordan,UT
78 full width HP dana44 and 9inch.
Disc brakes front and back.
5.13 gears, welded front and back.
The 44 has the flat top nuckles off a 3/4 ton truck but made to work with the 1/2 ton brakes so you can still run the 15" wheel.
Also the tie rod is 2" higher then the stock nuckles.
Has custom coil mounts to bring the coil springs in so there strait up and down..axles shafts are stock as far as I know but do have the solid spicer joints.
Should be good for a jeep but I'm not 100%
Asking $700 for both as-is but will lower the price a little if ya don't need the rear calipers. (chevy calipers)
My bead lock wheels will be forsale when the axles sell.
Disc brakes front and back.
5.13 gears, welded front and back.
The 44 has the flat top nuckles off a 3/4 ton truck but made to work with the 1/2 ton brakes so you can still run the 15" wheel.
Also the tie rod is 2" higher then the stock nuckles.
Has custom coil mounts to bring the coil springs in so there strait up and down..axles shafts are stock as far as I know but do have the solid spicer joints.
Should be good for a jeep but I'm not 100%
Asking $700 for both as-is but will lower the price a little if ya don't need the rear calipers. (chevy calipers)
My bead lock wheels will be forsale when the axles sell.
