UNSTUCK
But stuck more often.
My new house needs some electrical work done in the garage. I want to put in one dedicated 110 outlet on a 20 amp fuse, a second quad outlet on its own 20 amp fuse, and then a 50 amp 220 for my welder.
My main power box is located right on the outside of my garage, so it should be very easy to get the wiring into the garage. The outlets will all be located on that same wall. I figure I will need about 10 feet of wire for the single 110 and 220v and then around 25 feet of wire for the quad outlet that will be down the wall a ways.
The wall is rough drywalled so it will need to be cut and the studs drilled to run the wire, then the drywall needs be repaired. The 110v boxes can be mounted right to the drywall, but I want something stronger for the 220. I'm thinking something like a ceiling fan mount that attaches to the studs. I pulled my last box out of the wall that was only mounted to the drywall.
You must be licensed and this work should be done to any codes.
Feel free to post up here or call me at 8o19189784 for more information or to quote me. Once the job is done and I can use my welder again, I would be willing to trade any welding work you may need. I would like it done in the next week or so.
Thanks, Josh.
My main power box is located right on the outside of my garage, so it should be very easy to get the wiring into the garage. The outlets will all be located on that same wall. I figure I will need about 10 feet of wire for the single 110 and 220v and then around 25 feet of wire for the quad outlet that will be down the wall a ways.
The wall is rough drywalled so it will need to be cut and the studs drilled to run the wire, then the drywall needs be repaired. The 110v boxes can be mounted right to the drywall, but I want something stronger for the 220. I'm thinking something like a ceiling fan mount that attaches to the studs. I pulled my last box out of the wall that was only mounted to the drywall.
You must be licensed and this work should be done to any codes.
Feel free to post up here or call me at 8o19189784 for more information or to quote me. Once the job is done and I can use my welder again, I would be willing to trade any welding work you may need. I would like it done in the next week or so.
Thanks, Josh.
Last edited: