- Asking Price
- $6500.00
- Condition
- Used - Good Condition
I am sure I will regret this but I will throw it out there with everything else.
This is a complete setup and comes with the following:
Torchmate 4X4 Growth Series table
Hypertherm Powermax 85 CSA plasma cutter
Dell computer and monitor with cut program installed
Computer cabinet for shop environment
Some consumables
Assembly instructions, manuals, etc.
I was running this table at another location and just don't have the space in my shop and I need the cash so I will put it out there for the group.
The only issue with it is that the auto sense setting doesn't seem to be working correctly so it will crash and pop the magnetic head off, might just need to clean up a connection somewhere but haven't had time to figure it out. I have just been running it at a fixed height and it has been working fine that way.
It is not currently set up to run in my shop, I just got it onto some casters but need to brace the legs so I can at least move it around, then if I can make space and sell some other stuff I will keep it.
I might be willing to sell the table separate from the plasma cutter if you already have one, I love this machine I think it will cut up to 1 1/4" so I am ok with hanging onto it.
Make me an offer if your interested.
eight5six eight4six six4two7
This is a complete setup and comes with the following:
Torchmate 4X4 Growth Series table
Hypertherm Powermax 85 CSA plasma cutter
Dell computer and monitor with cut program installed
Computer cabinet for shop environment
Some consumables
Assembly instructions, manuals, etc.
I was running this table at another location and just don't have the space in my shop and I need the cash so I will put it out there for the group.
The only issue with it is that the auto sense setting doesn't seem to be working correctly so it will crash and pop the magnetic head off, might just need to clean up a connection somewhere but haven't had time to figure it out. I have just been running it at a fixed height and it has been working fine that way.
It is not currently set up to run in my shop, I just got it onto some casters but need to brace the legs so I can at least move it around, then if I can make space and sell some other stuff I will keep it.
I might be willing to sell the table separate from the plasma cutter if you already have one, I love this machine I think it will cut up to 1 1/4" so I am ok with hanging onto it.
Make me an offer if your interested.
eight5six eight4six six4two7
