ZJ dilemma

[GVR4Quinn]

So I put my RE puck lift on this past Sunday and I'm doing some measuring and come to find out my front driver side is sitting about an inch lower than the 3 other corners, so I'm assuming my coil spring is either starting to sag or it was replaced with a non-upcountry one therefore my inch off on the height. Now with that my dilemma is that I can't get the upcountry springs anymore from the dealer which was my first option to do and just replace both front ones, now do I go digging thru the junkyards or so I do something else or does someone have some good front upcountry springs to sell me? Sorry for the long story just trying to explain my situation and looking for ideas. Thanks in advance

 

[N-Smooth]

You could always get another rubber coil isolator and add it to the one side. IIRC they are just under an inch. Also, I'm pretty sure my jeep doesn't measure the same on any of the corners... it's a unibody

 

[gertsch]

What he said. ^

 

[GVR4Quinn]

Yeah you both are probably right that would be much easier than trying to find the right one in the junk. Thanks guys.