Sandblasting cost
- Thread starter CSR
- Start date
yz250_
Active Member
- Location
- Washington, UT
Most charge by the hour. Usually $100-$125/hour
muleskinner
Well-Known Member
- Location
- Enoch, UT
Blast Products
820 Warm Springs Rd # 820, Salt Lake City, UT 84116
(801) 532-1551
820 Warm Springs Rd # 820, Salt Lake City, UT 84116
(801) 532-1551
scoutabout
None
You need to go to Dino's Sandblasting in Lindon. I've had them do piles of stuff for $40.
Dino's is the only blaster I've worked with, and where I was basing my prices off of. Seemed like he was rather fair in his prices and not out to screw you. I was pleased with his work too, he didn't miss any spots.
RockChucker
Well-Known Member
- Location
- Highland
Chris, I had my tube fenders blasted at stripped right down the street from TeraFlex. I think it was like $30. I'm sure your axle wouldn't be too much more than that. Talk to Greg down there, or I'll talk to you at work tomorrow or something
scoutabout
None
I'd agree! I usually have tried to go over there during the day when they're fired up and blasting, slip my stuff in and they're usually cool to charge reasonably.
Yeah, Stripped quoted me $30. Seems pretty good.
- Location
- Stinkwater
Bumping an old thread, any other recommendations for a small job, preferably on the west side? Stripped is between shops and couldn't get me in. I'd rather not drive to Lindon if I can help it.
wheelewagon
Active Member
- Location
- West valley
Armor powdercoating does sand blasting
What do you need blasted? I may know a guy. but it has to fit in an auto-blast cabinet, that has a table that holds a piece about 24x24x18, it uses steel-shot, (not sand, or soda) and works really well.
- Location
- Stinkwater
Exhaust manifold, I think it's a little bigger than that.
I just dropped it off at Armor Coatings, they're going to work it in and probably have it for me by this afternoon. What a cool couple of guys.
Last edited:
Post up what you paid, if you don't mind.
- Location
- Stinkwater
They said their minimum charge is $40, then they went and charged me $30. Had it ready for pickup a couple hours later. Good guys, for sure.
R
rockdog
Guest
I can't believe these guys are literally right down the street from me and I've never had em do anything for me. My snow plow blade for my truck is getting rusted. I think I'll take it to them this summer and get it blasted.
I have a neighbor that will occasionally put up a sign that says he does all sorts of things including sandblasting, He doesn't leave the sign up very long (I suspect someone hassles him about running a business from his house) I keep meaning to get the phone number off it and give him a call. I wonder if that is the guy you know, near 56W and 54 S?
Nathan