DaveB

I saw an advertisement on a Mexican restaurant for "Purina el polllo" which sounded like something to feed the dog. The online...

I pulled the heads on the engine in my Commando to swap on some aftermarket heads and found issues in three of the cylinders. This motor...

Greg, I notice in your last picture that you have the thermostat bypass hose connections blocked off. Normally there is a hose from the...

I'm with DAA I was old when all of these bands came out and never listened to any of it except if my kids subjected me to it.

The motors need fuel, spark, and compression to run. When it dies pull the plug and check for spark. Then see if the plug is wet or dry...

That was one of the first things I did, so a good suggestion.

I sent SOS an email thinking it would take a while and they contacted me right away. The tech just left and we have heat again. I told...

The pilot flame sensor is working and the control board senses it and turns on the main gas valve. The problem is that the gas doesn't...

Thanks, I'll do some calling

Our furnace went out yesterday and its getting cold in the house. I went through the ignition cycle and everything works except the main...

Nothing too new for me to report on but Saturday I finally finished the two big projects I have been working on. My friends 02 Ram V10...

On my 73 Commando I swapped the bull nose for a CJ hood and grille with home made fenders. I also used two commando frames to make the...

One of my neighbors that I help out with Jeep problems brought their son's 97 TJ by for me to look at. All forward gears worked fine but...

Spent yesterday installing an 8.0 L Dodge V10 in my friends truck, what a pain.

I just wrapped up a motor rebuild for my old Polaris snowmobile. I took the damaged pistons and cylinders off the 500 motor and...