kirk86CJ
Registered User
- Location
- Riverton, Ut
I am building this cage. I still plan on adding spreaders - I assume 2 spaced about 8" apart running from the A Pillar to the B Pillar. (Then back to the corners from B-C) My head ends up a little close, so I was wondering about putting a bend in the spreaders so they go up an inch or two (from the A, then back down to the B Pillar - assuming I would put the bend close to the B pillar.
I have seen people put bends in the spreaders when the height of A-B is different, but I'm wondering if anyone has pictures, or opinions on how it would look when A-B is the same height.
Thanks
Kirk
I have seen people put bends in the spreaders when the height of A-B is different, but I'm wondering if anyone has pictures, or opinions on how it would look when A-B is the same height.
Thanks
Kirk