Recent content by SRSCOUT

No I haven't seen Dana Brand gears for the Ford 9". I wasn't aware that they were available. I will look into that.

So would it be that much of an upgrade from a Dana 44? I have Moser shafts in my 44 that's in the rig now. So is a 9" enough of a gain to justify the expense, or would the next logical upgrade be a Dana 60?

After rebuilding the 9" in my son's 78 F-150 I got thinking about it as a crawler axle. Yes it's got a low pinion but in a rig with plenty of rear drive line (such as an early Bronco) that wouldn't be too big of an issue. It looks like it would have really good clearance. I have read posts...

Yea, that's where I saw them I think. The only other gears I am really familiar with are Dana, but they don't have them for the 9" as far as i can tell. I did find Yukon, but I haven't had any experience with them either.

I am regearing my sons F-150 from 3.54's to 4.10. For the 9" rear I have seen good deals on G2 brand gears (I have a set of Dana/Spicer gears for the front 44). I have no experience with this brand and was wondering if anyone had used it? Quality etc. Thanks.

The safety inspection process being discontinued isn't going to change the vehicle equipment laws at all. Everything will remain the way it is, it will just now be up to the patrol officer to enforce these laws rather than the individual at the garage. After speaking with a mechanic friend of...

So how big of a deal was the cutting/welding on the TMR kit?

So did your shave job eliminate the bottom bolt? If so do you have any trouble with the diff cover leaking?

I don't suppose you have pictures of your shave job do you? I'm interested in what it would look like done.

Just curious. When you break your 9" what is breaking? Shafts, center section?

Thenag so I read your linked post. Is going with the cable E Brake as big a pain as it sounds like? I would really like to have one as I'm running a 4spd for now.

OK. It sounds like maybe I'm worrying about something that doesn't matter. No I'm not a competitive driver, I just enjoy more extreme trails than most do. I accepted many years ago that occasionally breaking parts was part of the game. I just don't like to break any more than necessary. I pulled...

What size tires do you run on the Wrangler with the 14 in it?

Are you running stock 30 spline shafts, or hardened 35 spline?

Yea the 14 is built like a brick crap house for sure. Only thing I worry about is on 35's will I be dragging it everywhere I go. I do have the 31 spline big bearing 9" I could use. It would have a lot more clearance. When I was running standard width on my Scout I had 44's front and rear ( they...