Recent content by gr8outdoorzman

I need a passenger side corner for my softtop. I have misplaced it in my garage and I have torn through it twice now with no luck. Anyone have an extra one in your garage? text me at 920-277-4six50

I am need a rear drive shaft for my cj-7 colapsed size 19 3/4"ish Doesn't need to be anything special. it probably won't be used for long. i also need a skid plate for my cj. I converted to an automatic trans. so i think the skid plate is different. But someone can tell me otherwise. But i...

I am heading to vegas on the 18th. willing to haul anything that would fit into an 8 foot bed. as long as im not taking to far of a detour away from I-15. And returning on the 4th. text 920-277-4650

That's what she said :D

Thats a great thread. wish i new what the MPG ended up being. but i guess we won't find out till the odometer gets fixed

ok i will bite. how or where do i need to be looking for a 5.3 donor. cause i have a buddy that will sell me an early 90s xj that was rolled for under $1k. but worse case i have seen them go for 1500ish. the cherokee has everything i need for the drivetrain. engine, trany, t-case and puter...

So i am sure there is a thread already on this, but i can't find it. So if anyone has done this or tried, could you let me know how it worked out. i think that i saw someone on here say that they bought a xj motor and transmission and it didn't fit in there stock 4.0 tj. Is this corect or did...

what happens if you plan to use the vehicle for off road use only. does it still need to be registered and does it still need the emission...blah blah blah

To all???

i am from a state that doesn't do emissions and have heard that vehicles with a motor swap. 1 need to be of the same year or newer and 2 need to be a motor swap that was an option from the factory. do both these rules fall into efect here in utah? and if not would i be able to put a...

pm sent thanks

i am just looking for easiest/cheapest axle option since its rock'n the jack stands on all four corners. want to get something safe enough together so i can rock it up to safety and emissions. was hoping that i could strip an xj or zj and get it titled.

i was told that a cherokee front axle will bolt right under a tj. i was wondering does anyone know if a grand cherokee front and rear bolt right in under the tj too? thanks

Just making sure i understand ya...The flywheel that i am already using on the 151 4cyl. is the correct flywheel to use for the over powered 350 8 cyl. Granted its probably going blow up within the first couple of months.:rofl:

I have been looking around for flywheels that work with a SB Chevy and Jeep T-5 transmission. The T-5 is currenty behind the 4 cyl pontiac engine so it already has a chevy bell housing. My questions are. does the flywheel that is hooked to the pontiac engine the same as the sb chevy and will...